Nikon EM User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Exposure
comper\sation
Meter power
source
Meter ON/OFF
switch
Battery power
checker
Film speed
range
Frame counter
Film rewind
speed for lens aperture set is
approx. 1/30sec. and below, or
approx. 1/1000sec. and above
Approx. + 2 E V when exposure
compensation button is kept de
pressed as shutter release button
is pressed
Two 1.5V silver-oxide batteries
(S-76 type)
Meter switched on when shutter
release button is pressed; stays
switched on for several seconds
after finger is lifted off button
LED lamp lights up to indicate
sufficient power availability
when power check button is
pressed
ASA 25^1600
Shows number of frames ex
posed; automatically resets to
“S” when camera back is open
ed; automatic operation starts
from frame i
Manual; film rewind crank rotat
ed after film rewind button is
depressed
Flash
synchronization
Motor drive
coupling
Camera back
Body finish
Accessories
provided
Dimensions
Weight
Built-in ISO-type hot-shoe; auto
matic flash sync at 1/90 sec.
with SB-E Speedlight Unit which
activates camera’s ready-light
when flash operation is ready;
ready-light “blinks" to signal in
correct
ASA/aperture
combi
nation; M90 shutter operation
mode selector setting used with
other electronic flash units, pro
viding flash sync at 1/90sec.;
bulb-type units not usable
Electrical contact and coupler
built-in for operation with MD-E
Motor Drive
Swings open when film rewind
knob is pulled up; memo holder
provided
Black
Camera body cap, triangular
grommets for neckstrap and two
1.5V silver-oxide batteries
135mm(W)x 86mm (H)x 54mm (D)
460g (body only)
All specifications are subject to change without notice.
33