Craftsman 113.244513 - Manual (Page 8)

assembly
2. Securely clamp board to workbench using
“C” clamps.
NOTE: Supporting surface where band saw is
mounted should be examined carefully after
mounting to insure that no movement during use
can result. If any tipping or walking is noted,
secure workbench or supporting surface before
operating band saw.
CLAMPING BANDSAW TO WORKBENCH
The Band Saw can be clamped directly to a
workbench using two (2) or more “C” clamps on
base of unit.
INSTALLING THE TABLE
Apply a coat of automobile wax to the table top
and inside surfaces of trunnion that slide on
frame.
1. Loosen the guide bar lock knob and position
the upper guide assembly all of the way up.
Tighten lock knob.
2. Locate two (2) knobs and two (2) 17/64 x
47/64 X 1/16 washers in loose parts bag, and
the table assembly in loose parts.
3. Place table assembly onto band saw frame
with thè trunnion against mounting rib in
frame.
GUIDE BAR
LOCK KNOB
UPPER
GUIDE
ASSEMBLY
TRUNNION'
Hold table assembly against the frame and
install two (2) table lock knobs and washers
as shown through the trunnion slots and
tighten.
BAND SAW
FRAME
TABLE LOCK
KNOBS