Craftsman 320.28190 - Manual (Page 5)

® ALWAYS SECURE YOUR WORK. Use ciamps or a vise to hold work piece
securely. It is safer than using your hand and frees both hands to operate tool.
® USE SAFETY EQUIPMENT. Always wear eye protection. Dust mask, non­
skid safety shoes, hard hat, or hearing protection must be used for appropri­
ate conditions,
» DO NOT USE ON A LADDER or unstable support Stable footing on a solid
surface enables better control of the tool in unexpected situations.
TOOL USE AND CARE
A WARNING: BE SURE to read and understand ail instructions before op­
erating this router. Failure to follow all instructions listed below may result in
electric shock, fire and/or serious personal injury.
» ALWAYS use clamps or other practical ways to secure and support the
work piece to a stable platform. Holding the work by hand or against your
body is unstable and may lead to loss of control.
® DO NOT force the tool. Use the correct tool and bit for your application.
The correct tool and bit will do the job better and safer at the rate for which it is
designed.
0 DO NOT use the tool if switch does not turn it “On” or “Off.” Any tool that
cannot be controlled with the switch is dangerous and must be repaired.
® DISCONNECT the plug from the power source before making any adjust­
ments, changing accessories or storing the tool. Such preventive safety
measures reduce the risk of starting the too! accidentally.
® NEVER leave the tool running. ALWAYS turn it off. DO NOT leave the too!
until it comes to a complete stop.
® STORE idle tools out of the reach of children and other untrained per­
sons. Tools are dangerous in the hands of untrained users,
8 MAINTAIN tools with care. Keep cutting tools sharp and clean. Prop­
erly maintained tools with sharp cutting edges are less likely to bind and
are easier to control.
8 CHECK for misalignment or binding of moving parts, breakage of parts, and
any other condition that may affect the tool’s operation, if damaged, have the tool
serviced before using. Many accidents are caused by poorly maintained tools.
« USE ONLY accessories that are recommended for this tool. Accessories
that may be suitable for one tool may become hazardous when used on another
tool.
28190 Manuai_Revised_074)409 Page 5