Craftsman 320.28190 - Manual (Page 18)

INSTALLING ROUTER MOTOR IN BASE
^ WARNING: NEVER use the router motor without installing it into either
a fixed or plunge approved base. Failure to do so could result in serious
personal injury and damage to router motor.
NOTE: Before installing router motor In fixed base, have the collet/nut and
router cutting bit you are going to use already installed in router motor. See
page 16 “INSTALLING AND REMOVING THE CUTTING BIT”
WARNING: ALWAYS turn router motor off and unplug router from power
source before making any adjustments or installing accessories. Failure to
turn router motor off and unplug router could result in accidental starting
which can cause serious personal injury.
INSTALLING ROUTER MOTOR IN BASE (Fig. 5)
1. Turn router motor off and
unplug from power source,
2. Place fixed base on
fiat surface.
3. With back of fixed base
facing you, open router
motor clamp (A).
4. Press in Coarse Adjust­
ment Knob (B) while you
align the router motor’s slot
with the pin in the fixed
base.
5. When the router motor’s slot
is aligned and engaged into the base’s pin, slide the router motor down into the fixed
base.
6. The router motor will now slide up or down to set coarse adjustments when
the coarse adjustment knob is pressed in.
7. After all adjustments are made, close the router motor clamp securely.
REMOVING ROUTER MOTOR FROM BASE (Fig. 5)
1. Turn router motor off and unplug from power source.
2. Place router (fixed base/router motor) on flat surface,
3., With back of router facing you, open the router motor clamp (A).
4. Push in coarse adjustment knob (B) to release router motor “Position groove”
(C) from lock hook (D) in base, while you lift router motor free of base.
5. Set motor upside down on its top cap with collet pointing up and remove cut­
ting bit. Store motor and base in carry bag when nojt being used.
28190 ManuaLRaflsed_07-<}409 ^ Page 18