Craftsman 320.28190 - Manual (Page 16)

INSTALLING AND REMOV­
ING THE CUTTING BIT (Figs,
3, 4 and 4a)
INSTALLING THE CUTTING BIT
1. Turn router motor off and
unplug from power source.
2. Remove router motor from
fixed base.
NOTE: See instructions on
removing and installing the
router motor in the fixed
base on page 18.
3. Set the router motor up­
side down on its top cap,
with colleVnut pointing up.
4. Press spindle lock button
to engage and lock the
spindle shaft and collet/nut
(Fig.3).
5. Place the wrench on the
collet/nut and turn coun­
ter-clockwise and loosen
coilet/nut slightly to accept
cutting bit shank.
6. Insert cutting bit shank into
collet/nut assembly as far
as it will go, then back the
shank out until the cutters
are approximately 1/8 to 1/4
inch away from the face of
the collet/nut (Fig. 4,4a)
7. With cutting bit inserted
and spindle lock button
pressed in engaging shaft,
place wrench on coilet/nut
and turn clockwise until
router cutting bit and col­
let/nut are firmly tightened.
28190 Manual Revised 070409 Page 16