Craftsman 107.289920 - Manual (Page 15)

OPERATION
..«P
JU U
Ground Speed Levers -
DRIVE Positons
Ground Speed Levers -
START/PARK Positons
Left
Ground Speed
Control Lever
Parking Brake Lever -
ENGAGE Positon
Parking Brake Lever -
DISENGAGE Positon
Fuel Tank
Cap
CONTROL FUNCTIONS
The information below briefly describes the
function of individual controls. Starting, stop­
ping, driving, and mowing require the combined
use of several controls applied in specific
sequences. To learn what combination and
sequence of controls to use for various tasks
please read the entire section.
Right
Ground Speed &
Parking Brake
Lever
Mower
lUpl Cutting
Height
Switch
Choke
Engine
Speed
(Fast)
Engine
Speed
(Slow)
START
Transmission
Release Levers
Mower Biade
Switch
Ignition ignii
Swi witch
Figure 6. Controls
Ground Speed Levers
These levers control the ground speed of the rider. The
left lever controls the left rear drive wheel and the right
lever controls the right rear drive wheel.
Pushing the levers out to the side, away from the opera­
tor’s lap (top inset. Figure 6), is the proper position for
starting the rider. Pulling the levers in across the opera­
tor’s lap puts the levers in DRIVE positions.
From DRIVE position, moving a lever forward increases
the FORWARD speed of the associated wheel. Pulling
back on a lever increases the REVERSE speed. The fur­
ther a lever is pushed, the faster the drive wheel will turn.
See DRIVING PRACTICE for steering instructions.
___ Parking Brake Lever
Move the parking brake lever (bottom inset. Figure 6) up
and across and into the locking notch to engage and lock
the parking brake. Move the parking brake lever across
and down to disengage the parking brake. The engine
will not start unless the parking brake is engaged.
NOTE: The parking brake must be disengaged before
operating the ground speed ievers.
Throttle/Choke Control (Choke-
0-Matic)
The throttle/choke controls the engine speed and choke.
Move the throttle/choke to the FAST position to increase
engine speed and SLCW position to decrease engine
speed. Always operate at full throttle. Move the throt­
tle/choke control to the CFICKE position for starting a
cold engine. A warm engine may not require choking.
15