Setting up the ground speed control levers – Craftsman 107.289920 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

SETTING UP THE GROUND SPEED
CONTROL LEVERS

1. Loosen (do not remove) the hardware securing the

ground speed control levers to the lever bases (see

Figure 3).

2. Raise the levers, aligning the upper hole in each lever

with the upper slotted hole in the lever base.

3. Install the hardware as shown in Figure 3. Tighten to

15-17ft-lbs (20-23 Nm).

NOTE: Ground speed control levers must be adjusted

prior to use. Refer to the “Ground Speed Control

Adjustment” section.

Figure 3. Setting Up the Ground Speed Control Levers