Craftsman 917.272233 - Manual (Page 11)

NOTE: To assist in locating hole in
flanged pin, the hole in pin is inline with
notch on head of pin. If necessary, move
mower side-to-side to give space
between plate and mower brackets.
IMPORTANT: Check belt for proper
routing in all mower pulley grooves.
10. Engage belt tension rod by pushing
rod into locking bracket.
^CAUTION: Belt tension rod is spring
loaded. Have a tight grip on rod and
engage slowly.
11 .Connect anti-sway bar to chassis
bracket under left footrest and retain
with double loop retainer spring.
12. If equipped, turn height adjustment
knob clockwise to remove slack from
mower suspension.
13. Raise deck to highest position.
14. Adjust gauge wheels before operating
mower as shown in the Operation
section of this manual.
CHECK TIRE PRESSURE
The tires on your tractor were overinflated
at the factory for shippirig purposes.
Correct tire pressure is important for best
cutting performance.
• Reduce tire pressure to PSl shovm in
“PRODUCT SPECIFICATIONS” section
of this manual.
CHECK MOWER LEVELNESS
For best cutting results, mower should be
properly leveled. See TO LEVEL MOWER
HOUSING” in the Senrice and Adjustments
section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
See the figures that are shown for replac­
ing motion, mower drive, and mower blade
drive belts in the Sen/ice and Adjustments
section of this manual. Verify that the belts
are routed correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your tractor,
check to see №at tiie brake is properly
adjusted. See TO ADJUST BRAKE" in the
Service and Adjustments section of this
manual.
V'CHECKUST
Before you operate and enjoy your new
tractor, we wish to assure that you receive
the best performance and satisfaction
from this quality product.
Please review the following checklist:
/ All assembly instructions have been
completed.
/ No remaining loose parts in carton.
/ Battery is properly prepared and
charged.(Minimum 1 hour at 6 amps).
/ Seat is adjusted comfortably and
tightened securely.
/ All tires are property inflated. (For
shipping purposes, the tires were
overinflated at the factory).
/ Be sure mower deck is properly leveled
side-to-side/front-to-rear for best cutting
results. (Tires must be properly inflated
for leveling).
✓ Check mower and drive belts. Be sure
they are routed property around pulleys
and inside all belt keepers.
/ Check wiring. See that all connections
are still secure and wires are properly
clamped.
While learning how to use your tractor,
pay extra attention to the following
important items:
/ Engine oil is at proper level.
/ Fuel tank is filled with fresh, clean,
regular unleaded gasoline.
/ Become familiar with ail controls - their
location and function. Operate them
before you start the engine.
/ Be sure brake system is in safe
operating condition.
11