Craftsman 536.888400 - Manual (Page 5)

Pajt^acked separately in cartm (not shown full size)
2- Nut, 5/16-18 Reghex
1 - container fuel
______ stabilizer
2 - Ignition Keys
(Attached to engine in
plastic bag) 1 ‘ Snow Chute Assembly
THIS SNOW THROWER HAS A TRACK DRIVE SYSTEM EQUIPPED TO GIVE YOU
FREE-WHEELING CAPABILITY
If your snow thrower must be moved without the aid of the engine, it will be easier to pull
the snow thrower backward by the handles, rather than pushing. For details on how to use
the freewheeling capability, see the Track Drive/Free-Wheel Feature paraqraoh in the
Operation section of this manual. a « k *>
track drive system may be tight but will loosen up as the snow thrower is ■
used. After first use, check the track for tension and adjust if necessary. See the Track
Adjustment paragraph in the Senrice and Adjustments section of this manual. Check track
adjustment and fasteners regularly.
ASSEMBLY
A
CAUTION: Always wear safety
glasses or eye shields while assembling
snow thrower.
TOOLS REQUIRED FOR ASSEMBLY
1
2
Knife to cut carton and plastic ties
1/2 inch wrenches (or adjustable
wrenches)
9/16 inch wrenches (or adjustable
wrenches)
3/4 inch wrenches (or adjustable
wrenches)
Pliers (to spread cotter pin)
Screwdriver
Measuring tape or ruler
The figure below shows the snow thrower in
the shipping carton.
2
-
The figure below shows the snow thrower
completely assembled.
References to the right or left hand side
of the snow thrower are from the viewpoint
of the operator's position behind the unit.
Auger drive lever _^Traction drive lever
Clutch cable
Shifter.
iever
Chute deflector
Shifter.
plate
^.»Height-
adjust skids