Craftsman 536.888400 - Manual (Page 15)

MAINTENANCE
CUSTOMER RESPONSIBILITIES
SERVICE
RECORDS SCHEDULE
SERVICE
DATPQ
Fill in dates as
you complete
regular service
After
first 2
Hours
Before
Each
Use
As
Needed
Every
10
Hours Every
25
Hours Each
Season
Before
Storage
L/n 1 Cw
Check Engine Oil Level
Change Engine Oil
I/'
Tighten all screws and nuts
Check Traction Clutch Cable
Adjustment (See cable Adj)
Replace Spark Plug
Replace Drive Belts
Lubricate all pivot points
Drain Fuel
Oieck Auger Clutch Cable
Adjustment (See Cable Adj)
Lubricate Disc Drive Plate Zerk
The warranty on this snow thrower does not
cover items that have been subjected to op­
erator abuse or negligence. To receive full
value from the warranty, the operator must
maintain the snow thrower as instructed in
this manual. The above chart is provided to
assist the operator in properly maintaining
the snow thrower.
Some adjustments will need to be made pe­
riodically to properly maintain your snow
thrower.
AFTER FIRST USE
• Check the tracks for tension and adjust if
necessary (see first figure on page 16).
• Check the track adjustment and fasteners
regularly.
• Be sure that ail fasteners are tight.
AS REQUIRED
The following adjustments should be
performed more than once each season.
• All screws and nuts should be checked
often to make sure they are tight, prefer­
able after each use.
• If any parts are worn or damaged, replace
immediately.
LUBRICATION CHART
Lubricate Disc Drive Plate Zerk
with a Hi Temp EP Moly Grease.
IS