Craftsman 358.352680 - Manual (Page 6)

operation
KNOW YOUR SAW
READ THIS OPERATOR’S MANUAL
AND SAFETY RULES BEFORE OPERAT­
ING YOUR CHAIN SAW. Compare the illustrations with your unit to tamiliarize
yourself with the location of the various controls and adjustments. Save this
manual for future reference.
Bar Tool
Chain
Hand Guard
Muffler
Front Handle
starter Rope
CRAFTSMAN*
33E
ON/STOP
Switch
Primer
Bulb
« Startan
Bar Oil Fill Cap Housing
Cylinder Cover
Fast Idle
Throttle LMk
Lockout /
Rear \ r.
Handle
Throttle Choke
Trigger Knob Bar Clamp
Fuai Mix Fill Cap
Depth Gaugm
___________________ 1^"
Bar Clamp Nuts ®tiide Bar
Chain
Direction
of Travel
OWSTOP SWITCH
The ON/STOP Switch is used to stop
the engine.
THROTTLE TRIGGER
The throttle trigger controls engine
speed.
THROTTLE LOCKOUT
The throttle lockout must be pressed
before you can squeeze the throttle trig­
ger. This feature prevents you from ac-
ddentally squeezing the trigger.
FAST IDLE LOCK
The fast idle lock holds the throttle trig­
ger in the starting position. Activate the
fast idle lock by pressing the throttle
lockout and squeezing the throttle trig­
ger. With the throttle trigger squeezed,
press the fast idle lock. Release the
throttle lockout and trigger while holding
the fast idle lock button.
CHOKE KNOB
The Choke Knob activates the choke to
provide additional fuel to the engine
during cold starting.
PRIMER BULB
The Primer Bulb circulates fuel to the
carburetor to provide quicker starting.
CHAIN TENSION
It is normal for a new chain to stretch
during first 30 minutes of operation. You
should check your chain tension fre­
quently. See Chain Tension under the
Sen/ice and Adjustments section.