Craftsman 580.762200 - Manual (Page 15)

STORAGE
AFTER EACH USE
Water should not remain in the unit for long periods of time.
Sediments of minerals can deposit on pump parts and
“freeze” pump action. Follow these procedures after every
use:
» Flush detergent hose by placing the injector filter into
a pall of clear water while running Pressure Washer
with nozzle in low pressure mode. Flush until you can
see clear water running through the tube.
s Shut off the engine and let it cool, then remove all
hoses.
To avoid engine problems, the fuel system should be
emptied before storage of 30 days or longer. Follow these
instructions:
PROTECT FUEL SYSTEM
® Remove all gasoline from the fuel tank to prevent gum
deposits from forming on these parts and causing pos­
sible malfunction of engine.
DANGER: Drain fuel into approved con­
tainer outdoors, away from open flame. Be
sure engine is cool. Do not smoke.
CAUTION: Be sure throttle lever is In
“STOP” position before you continue. If
you start engine without the proper water
supply connected, you can damage the
pump.________________
Empty the pump of all pumped liquids by pulling recoil
handle about 6 times. This should remove most of the
liquid in the pump.
Coil the high pressure hose and inspect it for damage.
Cuts in the hose or fraying of It could result in leaks
and loss of pressure. Should any damage be found,
replace the hose. DO NOT attempt to repair a dam­
aged hose. Replace the hose with the genuine
Craftsman part.
Drain water from hose and properly hang it on the
wire support provided on the guide handle.
“ Run engine until engine stops from lack of fuel. Make
sure you have water supply to pump inlet connected
and turned ON.
Note: If “Gasohol” has been used, complete above
instructions and then put 1/2 pint of unleaded gasoline
into fuel tank and repeat above instructions.
Note: Fuel stabilizer (such as STA-BIL) is an acceptable
alternative in minimizing the formation of fuel gum
deposits during storage. Add stabilizer to gasoline in fuel
tank or storage container. Run engine at least 10 minutes
after adding stabilizer.
CHANGE OIL
While engine Is still warm, drain oil from crankcase. Refill
with recommended grade. (See Changing Oil Level on
Page 12.)
OIL CYLINDER BORE
To protect the unit from freezing temperatures:
® Draw RV antifreeze (antifreeze without alcohol) Into
the pump by pouring the washer fluid into a 3-foot
section of garden hose connected to the inlet adapter
and pulling the recoil handle twice.
LONG TERM STORAGE
If you do not plan to use the Pressure Washer for more than
30 days, you must prepare the engine for long term storage.
Note: As always, prepare the pressure washer pump as
you would after each use.
* if possible, store your unit indoors and cover it to give
protection from dust and dirt. BE SURE TO EMPTY
THE FUEL
TANK.
® Cover your unit with a suitable protective cover that
does not retain moisture.
IMPORTANT: NEVER cover your pressure washer while
engine and exhaust area are wami.
15