Craftsman 132.24607 - Manual (Page 9)

Connecting Power Unit to
Misting Arm Assembly
Step 1
• Locate supply lines and power connector
at the power unit (AA) and uncoil to full
length
• Starting at the rear of tractor, feed supply
lines and connector assembly underneath
tractor body along right side of chassis
using care to avoid any potential interfer­
ence with tractor functionality.
IMPORTANT: To ensure lines will not be
damaged during tractor use, it is recommended
that you follow the exact path of existing electri­
cal supply lines installed on your lawn tractor.
• When the supply lines have exited the
underside of the tractor body, feed the
supply lines and power connector along
tractor chassis into engine compartment.
WARNING: Engine components may be hot.
Exercise caution when working in engine com­
partment to avoid personal injury.
Step 2
Continue to feed lines through the engine
compartment to the other side of the trac­
tor. Ensure that the supply lines are
routed safely away from the engine by
routing behind existing cables and wires.
NOTE; Do not install routing clips (G) at this
time. The lines are only run to make the con­
nection at this point in the installation. Finaliz­
ing installation will occur in subsequent steps.