Craftsman 132.24607 - Manual (Page 13)

• Using a supplied cable tie (J) organize any
excess iength of supply tubes and stow
behind battery {or along fuel tank if
equipped). Secure supply tubes to
electrical supply lines of tractor at
convenient locations to prevent line
damage during tractor operation.
step 2
• Using remaining cable ties (J) secure
supply tubes to tractor frame along length
under tractor body.
IMPORTANT: Use care not to over tighten
cable ties (J) and pinch supply lines as system
will not function properly. Cable ties are used
as a means to route lines safely away from heat
and possible pinch points during tractor opera­
tion. Following paths of your tractor’s electrical
supply lines ensures the best possible results.
• Reconnect negative (-) battery terminal to
tractor electrical system.
Before you operate your rider cooling
system, please review the following
checklist to ensure that you will obtain the
best performance from your system.
• Make sure all assembly instructions have
been completed with all bolts and nuts
tightened.
• Make sure hose connections at the filters
have been made and are fully engaged.
• Make sure electrical connection has been
made and is secure.
• Check routing of supply lines and make
sure they do not interfere with pedals,
pulleys, or belts.
• Check supply lines in engine compartment
and ensure they are safely routed away
from the engine.
• Check the supply lines as they exit the
power unit and ensure the bend is
sufficient and does not kink the hoses.
• Check the misting nozzle assembly to
ensure it does not interfere with tractor
controls.
• Turn tractor key to “ON” position and turn
cooling system power unit on.
• Confirm that the cooling system
pump starts.
• Confirm the flow of air from the
cooling nozzle.
• Open the tractor hood and
ensure that filter connections
are maintained.
You are now ready to enjoy the benefits of your
cooling system .
Proceed to the OPERATION section of this
manual to begin using.
Checklist
13