Craftsman 132.24607 - Manual (Page 17)

STORAGE
Empty water tank completely, replace
cap, and run system to evacuate all wa­
ter in supply lines.
Store misting nozzle assembly by folding
over dash of tractor.
Ensure the power switch on the power
unit is in the “OFF” position.
Clean debris from venting on rear of
power unit.
Clean the power unit thoroughly with mild
soap and water.
TROUBLESHOOTING
PROBLEM CAUSE CORRECTION
Pump Not
Running 1 .Switch in OFF Position
2.Tractor Key in OFF Position
1. Toggle Switch to ON Position
2. Tractor Key to ON Position
Unit not Misting 1 .Water tank is empty
2.Adjustment valve closed
S.Fill cap not sealed
4. Drain plug not sealed
5. Water filter needs replaced
6. Basket filter missing
1 .Fill tank with DRINKING WATER
2.Open adjustment valve
3. Properly seat fill cap
4. Properly seat drain plug
5. Replace water filter
6. Install basket filter
Water streaming from
Misting Nozzle
1 .Water in air supply lines
(Tank Overfull)
2. Adjustment valve setting
3. Air filter needs replaced
1. Drain tank and run system until
only air is emitted from nozzle
2. Close adjustment valve
3. Replace air filter
Inconsistent Misting 1 .Adjustment valve changing
position
1 .Adjust valve to desired mist den­
sity and tighten locking nut against
power unit housing
Water Dripping from
Drain Plug
1 .Drain plug not seated
2.Drain plug seal is missing or
damaged
1 .Properly seat drain plug
2.Replace drain plug seal
17