Support assembly, Awarning, Motor and blower to base assembly – Craftsman 152.213361 User Manual

Page 11

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

MOTOR AND BLOWER

TO BASE ASSEMBLY

AWARNING

MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.

1. Place motor and blower assembly and base on

their side with intake port pointing towards base.

Fig. 8

Align the four holes, two shown (A) on the top of
both side supports (B) with four holes in the motor
and blower assembly (C). See figure 8.

Place a 5/16” lock washer onto a 5/16-18 x 3/4” hex
head screw and insert the screw through the side

support and thread screw into tapped hole in the
motor and blower assembly. Do not completely
tighten.

Repeat this process for the remaining three holes;

tighten securely.

5. Figure 9 shows the motor and blower assembly

attached to the side supports.

SUPPORT ASSEMBLY

AWARNING

MAKE CERTAIN THE DUST COLLECTOR IS
DISCONNECTED FROM THE POWER SOURCE.

Fig. 10

1. Place the support (A) inside the two side supports

(B). MAKE CERTAIN THE SUPPORT IS
ATTACHED TO THE SIDE SUPPORTS CLOSEST
TO THE MOTOR. See figure 10.

2. Align the four holes (C) three shown, in the support

with the four holes in the side supports. See figure 10.

3. Insert a 5/16-18 x 5/8” hex head screw through the

side support and support.

4. Place a 5/16-18 flange hex nut onto the 5/16-18 x

5/8" hex head screw. Do not completely tighten.

5. Repeat Steps 3 and 4 for remaining three holes

and tighten securely.