Craftsman 137.224320 - Manual (Page 11)

ASSEMBLE THE BAND SAW TABLE (FIG. D, E, F, G)
Mounting the trunnion support bracket (FIG. D)
1
.
2
.
3.
4.
Remove the two hex head bolts (1) and washers (2),
located on the lower band saw housing.
Place the trunnion support bracket (3) on the saw body,
as shown, aligning the mounting holes.
Place the washers on the hex head bolts, and insert into
the threaded holes, through the bracket and saw body.
Tighten.
Thread a nut (4) onto the table stop bolt (5) and screw
both into the rear tab (6) on the trunnion support bracket.
Tighten the nut down onto the bracket tab.
FIG. D
Mounting the table (FIG. E, F, G)
6. On the underside of the table (7), place the scale
brackets (8) on the bracket mounting holes (9).
Be sure the long lock knob bolts (10) are placed
upwards through the bracket slots as shown. .
Place lock washers (11) on three short hex head
bolts (12). Thread the bolts through the mounting holes
and tighten.
7.
8
9. Turn the table right side up.
10. Remove the table insert (13) from the table,
11. Guide the table slot (14) over the saw blade and rotate a
1/4 turn, so the slot is perpendicular to the blade.
12. Placing the scale lock knob bolts (10) through the
trunnion bracket holes (15) as shown, lower the table
onto the trunnion bracket.
13.
14.
15.
Place a lock knob (16) on each scale knob bolt. Adjust
the table by aligning the zero scale mark to the scale
pointer (17), and tighten the knobs.
Replace the table insert (13), aligning the indents.
Place the table aligning pin (18) in the hole at the front of
the table, and tighten.
11