Craftsman 315.279840 - Manual (Page 9)

ASSEMBLY
UNPACKING
This product has been shipped completely assembled.
■ Carefully remove the tool and any accessories from the
box. Make sure that all items listed In the packing list
are included.
■ Inspect the tool carefully to make sure no breakage or
damage occurred during shipping.
■ Do not discard the packing material until you have
carefully inspected and satisfactorily operated the tool.
■ If any parts are damaged or missing, please call
1 -800'932-3t 88 for assistance.
PACKING LIST
Sander
Dust Bag
Paper Punch
Sandpaper (1) '
Operator's Manual
WARNING: if any parts are missing do not operate
' this tool until the missing parts are replaced. Failure
to do so could result in possible serious personal
irtjury.
WARNING: Do not attempt to modify this tool
^ or create accessories not recommended for use
with this tool. Any such alteration or modification is
misuse and could result in a hazardous condition
leading to possible serious personal injury.
WARNING: Do not connect to power supply until
‘ assembly is complete. Failure to comply could result
in accidental starting and possible serious injury.
OPERATION
A WARNING: Do not allow familiarity with tools
to make you careless. Remember that a careless
fraction of a second is sufficient to inflict serious
injury.
A WARNING: A!wa^ wear safety goggies or safety
glasses with side shields when operating power
tools. Fatfure to do so could result in objects being
thrown into your eyes resulting in possible serious
injury.
INSTALLING SANDPAPER
The cushion on the sender gives you the option of using
either non-adhesive sandpaper that clamps to the platen
or adhesive backed sandpaper with pressure sensitive
adhesive backing that sticks to the cushion.
INSTALLING NON-ADHESIVE SANDPAPER
See Figure 2.
■ Unplug the sender.
■ Inspect sandpaper before installing. Do not use if bro­
ken or defective.
■ If replacing sandpaper, remove old sandpaper. To
remove paper, release paper clamp by (ifltng up on
fever and disengaging it from the tab on the platen.
■ Insert end of new 1/4 sheet sandpaper approximately
(1/2 inch) under the paper clamp.
■ Lift up on paper clamp lever and lock into place. Apply
downward pressure to conform sandpaper to platen.
Wrap sandpaper around cushion. Lift lever on opposite
end of Sander and insert loose end of sandpaper under
the paper clamp. Fit sandpaper against cushion as
tight as possible.
Lift up on paper clamp lever and lock into place.