Cinnect hose and water supply to pump, A warilie – Craftsman 580.752130 User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
CflUTIOi! Alcohol-blended fuels (called gasohol. ethanol or
methanol) can attract moisture, which leads to separation and
formation of
acids during storage.
Acidic gas can damage the
fuel system of an engine while in storage.
To avoid engine
problems,
the
fuel system should
be treated
with a
fuel
preserver or
emptied
before storage of 30 days or
longer. If adding a
fuel
preserver,
fill
the fuel tank with fresh
fuel. If only partially filled, air in the tank will promote fuel
deterioration during
storage. If fuel
preserver is not used,
drain the fuel tank, start the engine and let it run until the fuel
lines
and carburetor are
empty. Use
fresh fuel next season.
See Storage for additional information.
NEVER
use engine
or carburetor cleaner products in the
fuel
tank
as
permanent damage may occur.
High Altitude
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane / 85 AKI (89 RON) gasoline is acceptable. To
remain emissions compliant, high altitude adjustment is
required. Operation
without this
adjustment will cause
decreased performance, increased fuel consumption, and
increased
emissions.
See a
qualified Sears dealer
for
high
altitude adjustment information. Operation
of
the engine at
altitudes below 2,500 feet (762 meters) with the high altitude
kit
is
not recommended.
Cinnect Hose and Water Supply to Pump
ИТ1СЕ
DO NOT run the pump without the water supply connected
and turned on.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
NOTE: Remove and discard the shipping caps from the
pump’s high pressure outlet and water
inlet before
attaching
hoses.
1.
Uncoil high pressure hose and attach one end of hose to
base of spray gun. Tighten by hand.
A WARilie
The high pressure stream of water that this
equipment produces can cut through
skin
and
its
underlying
tissues,
leading
to serious
injury
and
possible amputation.
NEVER connect high pressure hose to nozzle extension.
Keep high pressure hose connected to pump and spray gun
while system is pressurized.
Always be certain spray gun. nozzles and accessories are
correctly attached.
Attach other end of high pressure hose to high pressure
outlet
on pump. Tighten by hand.