Craftsman 580.752130 - Manual (Page 10)

3. Before connecting garden hose to water inlet, inspect
inlet screen (A). Clean screen if it contains debris or have
it replaced if damaged. DO MOT ryn pressure washer if
inlet screen is damaged or missing.
it of debris. Turn off water.
IMPORTANT: DO ¡MOT siphon standing water for the water
supply.
Use ONLY cold water {less than 100°F).
5. Connect garden hose (not to exceed 50 feet in length) to
water inlet. Tighten by hand.
iOTiCE
Using a One Way Valve (vacuum breaker or check valve) at
pump inlet can cause pump or inlet connector damage.
There MUST be at least ten feet of unrestricted garden hose
between the pressure washer inlet and any device, such as a
vacuum breaker or check valve.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
6. Turn ON water, point gun in a safe direction and squeeze
trigger to purge pump system of air and impurities.
A WiRilK
Risk of eye injury.
Spray can splash back or propel objects.
Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
NEVER substitute safety glasses for safety goggles.
Cheeklist Befsre Starting Engine
Review the unit to ensure you have performed ail of the
following:
1. Be sure to read Safety Rules and Operation sections
before using the cleaning system,
2. Make sure handle is in place and secure.
3. Check that oil has been added to proper level in engine
crankcase.
4. Add proper fuel to fuel tank.
5. Check for proper hose connections (high pressure and
water supply) and that there are no kinks, cuts, or
damage to the high pressure hose.
6. Provide proper water supply (not to exceed 100°F).
10