Craftsman 580.752130 - Manual (Page 12)

10
.
Move throttle leverto
rabbit.
fast” position (A), shown as a
IIPORTANT: Before starting the pressure washer, be sure
you are wearing adequate safety goggles.
^ WiRiiiG
Risk of eye injury.
Spray can splash back or propel objects.
Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
NEVER substitute safety glasses for safety goggles.
NOTE: This unit is equipped with a ReadyStart™ engine. A
ReadyStart™ engine means there is no priming or choking
required.
11. When starting engine, position yourself as
recommended and grasp starter grip handle and pull
slowly until you feel some resistance. Then puli rapidly
to start engine.
A WARilii
starter cord kickback (rapid retraction) can result
in bodily injury. Kickback will pull hand and arm
toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
NEVER pull starter cord without first relieving spray gun
pressure.
When starting engine, pull cord slowly until resistance is felt
and then puli rapidly to avoid kickback.
After each starting attempt, where engine tails to run, always
point spray gun in safe direction and squeeze spray gun trigger
to release high pressure. Engage spray gun trigger lock.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
2. Return recoil starter slowly. DO NOT let rope “snap
back” against starter.
NOTE: Always keep the throttle lever in the “Fast” position
when operating the pressure washer.
A WAmma
The high pressure stream of water that this
equipment produces can cut through skin and its
underlying tissues, leading to serious injury and
possible amputation.
Spray gun traps high water pressure, even when
engine is stopped and water is disconnected.
which can cause injury._______________________
DO NOT allow CHILDREN to operate pressure washer.
Keep high pressure hose connected to pump and spray gun
while system is pressurized.
NEVER aim spray gun at people, animals, or plants.
DO NOT secure spray gun in open position.
DO NOT leave spray gun unattended while machine is running.
NEVER use a spray gun which does not have a trigger lock or
trigger guard in place and in working order.
Always be certain spray gun, nozzles and accessories are
correctly attached.
^ WiRiiiG
M
Contact with muffler area can result in serious
burns.
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
DO NOT touch hot parts and AVOID hot exhaust gases.
Ailow equipment to cool before touching.
Keep at least 5 feet (152 cm) of clearance on all sides of
pressure washer including
overhead.
Code of Federal Regulation (CFR) Title 36 Parks, Forests, and
Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to LISDA Forest service
standard 5100-1C or later revision, in the State of California a
spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws.
12