Craftsman 580.752130 - Manual (Page 16)

MAINTENANC
OWNER’S RESPONSIBILITIES
Follow the hourly or calendar intervals, whichever occurs first
More
frequent service is required when operating in adverse conditions noted below.
J
MfllMTENflNCE SCHEDULE
MAINTENANCE TASK
Before
Each Use
OPEKI
Every 25
Hours or
Yearly
ITINÛ INTER
Every 50
Hours or
Yearly
VALS
Every 100
Hours or
Yearly
100-300
Hours
SERVICE DATES
FILL IN DATES AS YOU COMPLETE
REGULAR SERVICE
PRESSURE WASHER
Check/ciean water Iniet screen
X'
Check high pressure hose X
Check detergent hose X
Check spray gun and assembiy lor leaks X
Purge pump of air and contaminants X
Prepare pump for storage below 32"F See W inter Storage
ENGINE
Check oil level
X
Clean debris X
Change engine oil X'
Service air cleaner X*
Service spark plug X
Service spark arrester X
Clean cooling system X'
Clean combustion chamber X
Prepare for storage If unif is to remain idle for longer than 30 days.
Clean if clogged. Replace if perforated or torn.
Change oil after the first (5) operating hours and every 50 hours or yearly thereafter. Change sooner when operating under dirty or dusty conditions.
Replace more often under dirty or dusty conditions.
GENERAL
RECOMMENDATIONS
Regular maintenance will improve the performance and
extend the life of the pressure washer. See any Sears or
other qualified service dealer for service.
The pressure washer warranty does not cover items that
have been subjected to operator abuse or negligence. To
receive full value from the warranty, the operator must
maintain pressure washer as instructed in this manual
including proper storage as detailed in Storage.
Some adjustments will need to be made periodically to
properly maintain your pressure washer.
All service and adjustments should be made at least once
each season. Follow the requirements in the Maintenance
Schedule chart above.
NOTE: Once a year you should clean or replace the spark
plug
and replace the air filter. A new spark plug and clean air
filter assure proper fuel-air mixture and help your engine run
better and last longer.
EMISSION CONTROL
Maintenance, replacement or repair of the emission control
devices and systems may be performed by any non-road
engine repair establishment or individual.
BEFORE EACH USE
Check engine oil level.
Clean debris.
Check water inlet screen for damage.
Check high pressure hose for leaks.
Check cleaning tank for damage.
Check gun and nozzle extension assembly for leaks.
Purge pump of air and contaminants.
PRESSURE WASiER ilftliTEiiiCE
Oeai Debris
Daily or before use, clean accumulated debris from cleaning
system. Keep linkage, spring and controls clean. Keep area
around and behind muffler free from any combustible debris.
Inspect cooling air slots and openings on the pressure
washer. These openings must be kept clean and
unobstructed.
Cleaning system parts should be kept clean to reduce the risk
of overheating and ignition of accumulated debris.
• Use a damp cloth to wipe exterior surfaces clean.
* Use a soft bristle brush to loosen caked on dirt, oil, etc.
16