Installation step 7, Installation step 8, Install the lights and the lenses – Craftsman 139.53664SRT2 User Manual
Page 19: Attach the emergency release rope and handle
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

6. Attach the User Safety Instruction label to the wall
near the door control, and the Maintenance
Instruction label in a prominent location on the
inside of the garage door.
Page 32 explains how to use the door control.
Do NOT connect the power and operate the
opener at this time.
The trolley will travel to the
full
open
position but will not return to the
dose
position
until
the
sensor
beam
is
connected and properly aligned.
See
Safety
Reversing
Sensor
instructions
beginning on page 21.
Installation Step 7
Install the Lights and the Lenses
Install the lights:
• Install a 75 watt maximum light bulb in each
socket. The lights will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the lights will turn OFF.
• If the bulbs burn out prematurely due to vibration,
replace them with standard neck "Garage Door
Opener" bulbs.
Install the lenses:
• Apply slight pressure on the sides of each lens
and slide the tabs into the slots in the side panels.
• For convenience, the lenses may be instalied
after Adjustment Step 4 on page 30.
• Reverse the procedure to remove the lenses.
75 Watt Max.
Lens
Light Bulb
Guide
Lens
Tab
Installation Step 8
Attach the Emergency
Release Rope and Handle
* •
• Thread one end of the rope through the hole in
the top of the red handle so "NOTICE" reads right
side up as shown. Secure with an overhand knot.
The knot should be at least 1" from the end of
the rope to prevent slipping.
• Thread the other end of the rope through the hole
in the release arm of the outer trolley.
• Adjust rope length so the handle is 6 feet above
the floor. Secure with an overhand knot.
If it is necessary to cut the rope, heat seal the
cut end with a match or lighter to prevent
unraveling.
Do not use the red handle to pull the door
open or closed.
The rope knot couid become
untied and you couid fall.
Use the emergency
release only to disengage the trolley and, if
possible, only when the door is closed.
Garage doors are heavy. If the door is open
when the handle is pulled, the door could
close
inadvertently if it is not properly
balanced. Serious injury may result to persons
under the door. Make sure the doorway is clear
of persons and obstructions before pulling
handle when door is open.
Overhand
Knot
Trolley
— Trolley
Release Arm
Overhand
Knot
Emergency
Release Handle
19