Mamiub a problem, Problem – Craftsman 139.53920D User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
MAMiUB A
PROBLEM?
1 .R3y door will not close and the light bulbs blink
on my motor unit:
The safety reversing sensor
must be connected and aligned correctly before
the garage door opener wili move in the down
direction
• Verify the safety sensors are properly ¡nstailed,
aligned and free of any obstructions> Refer to
Installation Step 10: Install The Protector
Systerrf-
• Check diagnostic LED for flashes on the motor
unit then refer to the
Diagnostic Chart
on the
following page-
2, S/ly remotes will not activate the door:
• Reprogram remotes following the programming
instructions. Refer to
Programming-
•
If remote wiii still not aclivate your doop check
diagnostic LED for flashes on motor unit then
refer to
Diagnostic Chart on
the foliowtng page
3, ft/ly door reverses for no apparent reason:
Repeat safety reverse lest after adjustments to
force or travel limits. The need for occasional
adjustment for the force and limit settings is
normal. Weather conditions In particular can affect
door travel.
• Manually check door for balance or any binding
problems
• Refer to
Adjustment Step 2, Adjust the Force.
4,
My door reverses for no apparent reason after
fully closing and touching the floor:
Repeat
safety reverse test after adjustments to force or
travel limits. The need for occasional adjustment
for the force and limit settings is normal. Weather
conditions in particular can affect door travel.
• Refer to
Adjustment Step 1, Adjust the UP and
DOWN Travel Limits.
Decrease down travel by
turning dov/n limit adjustment screw clockwise.
Senefing Eye Safely Reverafeg
Sensor |Ambsr (ndiratof Light)
Receiving Eye Safely Reversing 5. My motor unit hums briefly: • First verify that the trolley is against the stop bo!t « Release the door from the opener by pulling the Emergency Release Rope. • Manually bring the door to a closed position • Loosen the chain by adjusting the outer nut 4 to 5 turns. This relieves the tension. » Run the motor unit from the remote control or door control. The trolley should travel towards • Decrease the UP travel by turning the UP Travel adjustment screw 2 full turns away from • Re-tighten the outer nut so the chain is a 1/2“ (13 mm) above the base of the rail. (When the door is reconnected and closed, the chain • If the trolley does not move away from the bolt, repeat the steps above. 33
Sensor
the door and stop. If the trolley re-engages with
the door, pul! the Emergency Release Rope to
disengage.
the arrow
will sag, This is normal.}