Craftsman 139.53920D User Manual

Page 24

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Text mode
Original mode

nKfn

nrvnDQ

ICL/Cl LJwv-/riClS

Please read and comply with the warnings and
reinforcement instructions on the previous page.

They apply to one-piece doors aiso.

• Center the door bracket on the top of the door, in

line vtfifh the header bracket as shown,- Mark either
the left and right, or the lop and bottom holes,,

* Drill 5/16“ pilot holes and fasten the bracket with

hardware suppiied.,

if the door has no exposed framing, drill 3/16" pilot

holes and fasten the bracket with 5/16"x1-1/2'' lag
screws (not provided) to the top of the door,

NOTE: The door bracket may be installed on the top
edge of the door if required for your installation.
(Refer to the dolled line optional placement drawing.)
Drill 3/16" pilot holes and substitute 5/16'‘x1-1/2" lag
screws (not provided) to fasten the bracket to the
door.