Craftsman 944.602951 - Manual (Page 7)

ASSEMBLY
Connect BLACKgrounding cable to negative(-) tenninal
with remaining hex bolt and keps nut. Tighten securely.
TERMINAL ;
COVER
DISCARD TERMINAL
PROTECTIVE CAPS
KEPS
HEX BOLT
POSITIVE (RED)
CABLE NEGATIVE (BLACK)
CABLE
FIG. 2
SEAT PAN
F(G.3
NSTALL SEAT (See Fig. 4}
Adjust seat before tightening adjustment knob.
Remove adjustment knob and flat washer securing seat
to cardboard packi ng and set aside for assembly of seat
to tractor.
Pivot seat upward and remove from the cardboard
packing. Remove the cardboard packing and discard.
' Place seat on seat pan so head of the shoulder bolts are
positioned over large slotted holes in pan.
' Push down on seat to engage shoulder bolts in slots and
pull seat towards rear of tractor.
Pivot seat and pan forward and assemble adjustment
knob and flat washer loosely. Do not tighten,
’ Lower seat into operating position and sit on seat.
■ Slide seat until a comfortable position is reached which
allows you to press clutch/brake pedal all the way down.
• Get off seat without moving its adjusted position.
■ Raise seat and tighten adjustment knob securely.
ADJUSTMENT
KNOB
FIG. 4
NOTE: You may now roll or drive your tractor off the skid.
Follow the appropriate instruction below to remove the
tractor from the skid.
TO ROLL TRACTOR OFF SKID (See Operation
section page 10 for location and function of
controls)
• Press lift lever plunger and raise attachment lift lever to
its highest position.
• Release parking brake by depressing clutch/brake pedal.
• Place freewheel control in freewheeling position to
disengage transmission (See “TO TRANSPORT in the
Operation section of this manual).
• Roll tractor fonward off skid.
• Remove banding holding deflector shield up against
tractor.
TO DRIVE TRACTOR OFF SKID (See Opera­
tion section page 10 for location and function
of controls)
^WARNING: Before starting, read, understand and follow
all instnjctions in the Operation section of this manual. Be
sure tractor is in a well-ventilated area. Be sure the area in
front of tractor is clear of other people and objects.
•
Be sure all the above assembly steps have been
completed.
• Check engine oil level and fill fuel tank with gasoline.
• Place freewheel control in "transmission engaged" posi­
tion.
• Sit on seat in operating position, depress clutch/brake
pedal and set the parking brake.
• Place motion control lever in neutral (N) position.