Edging with a pilot bit (figs. 14 and 14a), Operation com – Craftsman 320.17541 User Manual
Page 25
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION com.
EDGING WITH A PILOT BIT (Figs. 14 and 14a)
The arbor-type bits with pilots are excelieni for edge shaping of any workpiece edge that
is either straight, or curved at a curvature as great or greater than the radius of the bit to
be used. The pilot prevents the bit from making too deep a cut; and holding the pilot firmly
in contact with the workpiece edge throughout prevents the cut from becoming too shallow.
Whenever the workpiece thickness, together with the desired depth of cut (as adjusted by
router depth setting) are such that only the top part of the edge is to be shaped (leaving at
least a 1/16-in. thick uncut portion at the bottom), the pilot can ride against the uncut
portion, which serves to guide it (see Ftg. 14).
If the workpiece is too thin or the bit set too low so that there will be no uncut edge to ride
the pilot against, an extra board to act as a guide must be placed under the workpiece
(see Fig, 14a). This “guide” board must have exactly the same contour - straight or curved -
as the workpiece edge. If it is positioned so that its edge is flush with the workpiece edge,
the bit wiil make a full cut (in as far as the bit radius). On the other hand, if the guide is
positioned as shown in Fig. 14a (out from the workpiece edge), the bit will make less than
a full cut - which will alter the shape of the finished edge.
NOTE:
The size (diameter) of the pilot that is used determines the maximum cut
width that can be made with the pilot against the workpiece edge (the small pilot
exposes all of the bit; the large one reduces this amount by 1/16-In.). Any of the
piloted cutter bits can be used without a pilot for edge shaping with guides.
Fig. 14
Spindle Lock
Motor Housing
Spindle
Fixed Base
base
Cutter-bit
Pilot
TOP EDGE SHAPING
Workpiece
Top Edge of Workpiece
A
WARNING:
Always securely clamp your workpiece and keep a firm grip
on the router base with BOTH HANDS at all times. Failure to do so could result
in loss of control causing possible serious personal injury.
25