Port configuration commands, Show port information – Cisco 1503 User Manual
Page 37
Using Your Hub Software 3-37
Port Configuration Commands
Port Configuration Commands
Use the commands in this section to display or edit information about any port in the stack.
show port information
Syntax:
show port information [hub id]
Mode:
Guest
Description:
Displays information about all the network ports on the selected hub.
Command Keyword Definition
• hub id—(Optional) Number used to identify the hub in a stack. An integer
between 1 and 5. Read the section “Hub ID Numbers” earlier in this chapter
for information about how to determine hub ID numbers.
Information is displayed as follows:
Hub> show port information 1
Hub id: 1
Port ID Admin Status
Link Status
Partition Status
------------------------------------------------------
1
enabled
Not connected
not partitioned
2
enabled
Not connected
not partitioned
3
enabled
Connected
not partitioned
4
enabled
Not connected
not partitioned
5
enabled
Not connected
not partitioned
6
enabled
Connected
not partitioned
7
enabled
Not connected
not partitioned
8
enabled
Not connected
not partitioned
Command Display Definitions
• Hub ID—Number used to identify the hub in a stack. An integer between 1
and 5. Read the section “Hub ID Numbers” earlier in this chapter for
information about how to determine hub ID numbers.
• Port ID—Number (1 through 8) of one of the yellow network station ports.
• Admin status—Whether or not the port has been manually disabled.
• Oper status—Whether or not the device connected to this port has a valid
connection to the hub.
• Partition status—Whether or not the port has been partitioned by the hub,
which usually happens as a result of a network loop.