Cisco 1503 - Manual (Page 29)

Using Your Hub Software 3-29
Management Configuration Commands
Management Configuration Commands
Use the commands in this section to configure community strings and trap managers, which
are required when using SNMP.
IP Parameter Commands
Use the commands in this section to configure the Micro Hub 1503 with IP parameters. The
hub must be configured with IP parameters to use SNMP, Telnet, and TFTP functions.
show ip configuration
Syntax: show ip configuration
Mode: Guest
Description: Shows the current configuration for IP, as shown below:
Hub> show ip configuration
IP address: 10.10.10.10
Subnet mask : 255.255.255.0
Gateway IP: 10.10.10.254
Command Display Definitions
• IP address—Hub’s IP address.
• Subnet mask—Hub’s subnet mask (the host address bits used for routing
traffic to the subnet).
• Gateway IP—Gateway used to pass trap messages from the hub to the
management stations, for example, the IP address of a router on the same
LAN as the hub.