Configuring trap managers, Show ip trap-managers – Cisco 1503 User Manual
Page 34
Command Summary
Cisco Micro Hub User Guide
3-34
Configuring Trap Managers
Use the commands in this section to configure the Micro Hub 1503 trap information. Trap
information enables the hub to send information to connected network devices. These
messages notify network devices about events on the network.
show ip trap-managers
Syntax:
show ip trap-managers
Mode:
Guest
Description:
Displays information about authorized trap managers as shown in the following
example:
Hub> show ip trap-managers
Index
IP Address
Community Name
Status
-----------------------------------------------
1
222.222.222.222
public
enabled
2
11.11.11.11
public
disabled
3
0.0.0.0
public
disabled
4
0.0.0.0
public
disabled
5
0.0.0.0
public
disabled
Command Display Definitions
• IP Address—IP address of the network management station.
• Community Name—Name used to identify an SNMP community.
• Status—Whether or not the community is enabled or disabled.