Sony KV-32XBR48 - Manual (Page 36)

IK
f
Operating a Cable Box or DBS Receiver
Setting the Manufacturer's
Code
You can program the supplied remote control
to operate a cable box or DBS receiver.
Press CODE SET, DBS/CABLE (FUNCTION),
the 0-9 buttons to enter the manufacturer's
code number (see the following chart), then
press ENTER.
For example, to operate a Sony DBS receiver;
FUNCTION
COM SET OKJCMU ^
T* Cp + (9
ENTER
Manufacturer code numbers
(cable box)
Manufacturer Code
Hamlin/Regal
Jerrold/G. I.
Oak
Panasonic
Pioneer
Scientific Atlanta
Tocom
Zenith
Manufacturer code numbers
(DBS receiver)
Manufacturer Code number
Sony 801 (preset code for
remote control)
General Electric 802
RCA/PROSCAN
802
222, 223, 224, 225, 226
201, 202, 203, 204, 205,
206, 207, 208, 218
227, 228, 229
219, 220, 221
214, 215
209, 210, 211
216, 217
212, 213
To operate the TV
Press TV (FUNCTION). Then use the TV
control buttons to control the TV.
For more details on operating the
cable box or DBS receiver
Refer to the operating instructions that come
with the equipment.
If the remote control doesn't work
• First, try repeating the set up procedures
using the other codes listed for your
equipment.
Tips
•
If more than one code number is listed, try entering
them one by one until you come to the correct code for
your equipment.
• If you enter a new code number, the code number you
previously entered at that setting is erased.
In some rare cases, you may not he able to operate
your equipment with the supplied remote control. In
this case, use the equipment's own remote control
unit.
Whenei’cr you remove the batteries
—
to replace
them, for example
—
if too much time is taken, the
code numbers may revert to the factory setting and
must he reset.
34