Sony LBT-D570 - Manual (Page 16)

-> continued
8
Press REC.
The REC and DO (pause) lamps light up
and deck B stands by for recording.
The O lamp lights up and the <1 lamp
flashes for a few seconds, then
disappears.
О
<1 Э-
1
‘ Side in recording
pause mode
If you want to start recording from the
reverse side, press <1 so that the <1
lamp lights steadily.
S Press 00 to release recording pause.
Recording starts.
10
Press CD O.
The CD player starts playing.
To Press
Stop recording □
Pause recording DD
To record with the surround effect
Press SURROUND so that "SUR l(H'»ill)"
appears in the display.
The equalizer you have adjusted will not be
recorded.
Note
If you want to record specific tracks of the
CD, the "program edit" feature will make it
easier.
Recording a CD:
Selecting Tape
Length (tape select
edit)
You can have the stereo system select and
indicate the most suitable tape length for
recording each disc automatically.
You cannot use tape select edit for discs
which contain 21 tracks or more.
CHECK
1
Press FUNCTION repeatedly until
"CD" appears in the display.
2
Press = OPEN and place a CD on the
tray.
Make sure the disc number in the
playing position in the display is the one
you want to record.
The total number of tracks and the
playing time appear in the display.
3
Press EDIT on the remote.
"TAPE SELECT" appears in the display
and the player divides the selections
automatically.
Then the display changes as follows:
TRPE SELEC
4
Press = EJECT and insert a blank tap>e
of the indicated length (or longer) into
deck B with the side you want to record
on facing forward.
Make sure the tabs on the cassette have
not been removed.
5
Select dual or single-sided recording.
To record Press DIRECTION
to select
One side of the tape
Both sides* CZl:) or RELAY
’ Recording always stops at the end of the
reverse side. Be sure to start from the
front side.
6
When you want to reduce the hiss noise
in low-level high-frequency signals.
Press EXDLBY NR so that "DOLBY NR
B" appears in the display.
7
Press CD SYNCHRO.
The REC and DD (pause) lamps light up
and deck B stands by for recording.
The t> lamp lights up and the flashes for a few seconds, then
disappears.
J
----------s
pause mode
If you want to start recording from the
reverse side, press -<] so that the indicator lights steadily.
8
Press DO on the tape player to release
recording pause.
Recording starts.
After about 10 seconds, the CD player
starts playing.
To stop recording
Press □.
To check the order
Press CHECK on the remote.
To cancel tape select edit
Press CONTINUE on the CD player.
^________ "■
TRPE-4L -ЬЧ».
flashing
"I 5 I Chapter 4: the Tape Player