Sony CDP-CX88ES - Manual (Page 22)

Playing CDs
4 Pross ENTRR.
The track being programmed
20
20 3 ,T
The disc being
programmed Playing order
5 To program other discs/tracks, do the tollo\ving:
To program Repeat Steps
All tracks of another disc(s) 2 and 4
Other tracks on the same disc 3 and 4
Other tracks on other discs 2 to 4
6 Press ENTER or to start Program Play.
To cancel Program Play
Press CONTINUE.
The programs remain even after Program Play ends
when you press ENTER or O in Program Play mode,
you can play the same program again.
When you press PROGRAM to select Program Play
during Continuous or Shuffle Play
The program will be played after the current track.
'Q' The program remains until erased
Even if you replace discs, the programmed disc and track
numbers remain. Therefore, the player will play the new
existing disc and track numbers. However, the
programed disc and track numbers that are not found in
the player or on the disc are deleted from the program,
and the rest of the program is played in the programmed
order.
'Q' You can select the program number (PROGRAM 1,2 or
3) by using the remote [Jj
Press PROGRAM on the remote repeatedly until the
desired program number appears in the display.
Checking the programmed order
You can chock vour program boforo or after vou start
playing.
Press CHECK.
Each time vou press this button, the display shows the
disc and track number of each step in the programmed
order, (When a whole disc is programmed as one step,
"ALL” appears instead of the track number.) After the
last step in the program, the display shows END
and returns to the original display.
Changing the programmed order
You can change your program before you start playing.
To You need to
Erase a track or disc Press CHECK until the track or
disc you don't want appears in
the display, then press CLEAR
Erase the last track or
disc in the program Press CLEAR. Each time you
press the button, the last
programmed track or disc will be
cleared.
Add tracks or discs to the
end of the program Follow the programming
procedure
Change the whole
program completely
Hold down CLEAR until "ALL
CLEAR" appears in the display to
erase the whole program, then
create a new program following
the programming procedure
Erasing the program stored in memory
1 Press PROGRAM repeatedly in the stop mode
until the program number (PROGRAM 1, 2 or 3)
you want to erase appears in the display.
2 Hold down CLEAR until "ALL CLEAR" appears
in the display.
Note
If you press one of the GROUP 1-8 buttons to start Group
Play, Program Play will be canceled (see page 30).
22^