Sony MDS-JE510 - Manual (Page 29)

Editing Recorded MDs
3 Press DISPLAY/CHAR to select the character
type as follows:
To select Press DISPLAY/CHAR repeatedly
until _
Uppercase letters "A" appears in the display
Lowercase letters "a" appears in the display
Numbers "0" appears in the display
■ H ■
4 S
• 7 • fl 10
11 U.1J U 1$
It 17 10
4 Turn AMS to select the character.
Repeat Steps 3 to 5 until you have entered the
entire title.
If you entered the wrong character
Tress or ►► until the chanictor to Ix' correctt*d starts
flashing, and repeat Steps 3 to 5 to enter the correct
character.
To erase a character
Press or ►► until the character to be erased starts
flashing, then press EDIT/NO.
To enter a space
Press AMS or ►► while the cursor is flashing.
Press YES.
This completes the labeling procedure and the
title appears on the left side of the display.
4 S
« 7 I • to
11 12 13 14 IS
1« 17 It
The selected character flashes.
Letters, numbers, and symbols appear in
sequential order as you turn AMS.
You can use the following symbols in titles:
To cancel labeling
Press ■.
Note
You cannot label a track or an MD while you are recording
over an existing track.
(Continued)
You can press DISPLAY/CHAR to change the
character type at any time during Step 4 (see
Step 3).
5 Press AMS to enter the selected character.
The cursor shifts rightward and waits for the
input of the next character.
f 7 0 t 10
11 12J3 14 15
10 17 10
27