CLIFFORD 770 - Manual (Page 16)

13 © 2 0 0 6 d i re c t e d e l e c t ro n i c s
1. Turn the ignition on.
2. Enter PIN code (factory setting is 2).
3. After the last digit of the pin code is entered:
a. To disarm the system: press and release .
b. To enter valet ® mode: Press and hold
for
three seconds.
The LED status indicator will light steadily if you are entering Valet ®
Mode and will turn off if you are exiting Valet ® Mode.
To exit Valet ® Mode:
1. Turn the ignition on.
2. Enter PIN code.
3. After the last digit press for one second.
The LED will turn off.
remote valet ® mode
The operations described in this section refer to remote buttons.
Remember, the buttons used in all the instructions in this guide corre-
spond to a Standard Configuration remote. This may not be how your
remote is set up.
To enter Valet ® Mode, press twice and then . The
LED status indicator will light solid if you are entering Valet ® Mode, or
will turn off if you are exiting Valet ® Mode.