Sony GDM-2000TC User Manual
Page 11
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Note on steps 2 and 3
Do not place the sensor out of the displayed picture or
remove the sensor from the screen until the next message
appears. Place the sensor vertically to the screen.
4 Put the sensor on the mark and click it.
A sensor mark flashes on the screen and the message
below appears.
UNIFORMITY ADJUSTMENT
1 - Place Sensor over
Black Square
2. Click and hold until
NEXT Square appears
3 Repeat Process
FXITTMT)
□
5 Put the sensor on the mark and click it.
81 ,(9
X
9) marks appear sequentially. After you click the
last one, the finish message appears.
ADJUSTMENT COMPLETE
Press ENTER Key
SETEEIIS) EXlTtMENu)
Displayed
picture
Do not remove the sensor from the screen, until
the next black square appears. If the next mark
does not appear after a few seconds, there may
be a detection error. Reconfirm the location of
the mark, by placing the sensor on the mark
again, and click it.
' Press MENU to stop the adjustment.
' Place the sensor vertically to the screen to shield
the sensor from the outer light.
6 Press ENTER.
The menu appears.
11