Sony ICF-CD833 - Manual (Page 8)

Setting the Clock
Set the time when the CD or radio is turned off.
1 - Plug in the unit.
The display will flash "AM 12:00".
2 . While holding down TRACK/ENTER/
CLOCK, press either TUNING/TIME
SET + or - till the correct time appears
in the display.
When you release
TRACK/ENTER/
CLOCK, the clock begins to operate and
flashes.
• To set the current time rapidly, keep pressing
the + or - button while holding down TRACK/
ENTER/CLOCK.
• To set the current time from zero second, at
step 2, release TRACK/ENTER/CLOCK with the
time signal.
Playing a Disc
An 8 cm (3-inch) CD can be played without an
adaptor.
1. Slide PULL OPEN out to open the CD
compartment lid and place a disc.
Slide.
Label surface up.
Close the lid.
2 . Press CD ►!! and the display lig
"01". And the current number (
99) appears iii the display windt
After 10 seconds, the indication
becomes current time, but the "(
indication remains.
AU U o
u-
CD^
I r
( J
3 . Adjust VOLUME
Locating a Particular Portion
Locating a particular selection (AMS*)
To locate the beginning of the current sel
press 1^^ once.
To IcKate the next selection, press o:
Locating a particular point in a seiectic
(SEARCH)
To go back at high speed, keep pref
To go ahead at high speed, keep pre
• AMS is the abbreviation of Automatic N
Sensor.
• If you press repeatedly, the player
the previous selections. If you press
repeatedly, the player locates the next
selections and stops at the last selection.
• To stop play, press OFF/ALARM RESET.
• To pause, press CD ►!! and the "CD ►
indication flashes. To resume play, pres
CD Ml again.
• To change the clock mode to track mode
TRACK/ENTER/CLOCK.
Press TRACK/ENTER/CLOCK again, and
current time appears.
• To obtain a powerful bass, set MEGA B/J
ON.
• To eject a disc, slide PULL OPEN out.
• To handle compact discs
This way
Handle the disc
by its edge.
Do not touch tl
surface.
Do not stick paf
tape nor write
anything on the
surface.