Sony MDS-S35 - Manual (Page 8)

Recording on MDs
Useful Tips for Recording
SONY
1 . 1 . Ì
sj
.................................................
__L_J
1 r l
' lUi o
>10 DISPLAY
Checking the remaining recordable time on
the MD
• When you press DISPLAY while recording, the
remaining recordable time on the MD appears.
• When you press DISPLAY repeatedly while the
recorder is stopped, the display changes as follows:
total recorded time, remaining recordable time on
the MD, disc name (see page 12).
If "Auto Cut" appears in the display
The Auto Cut Function has been activated. This
happens when there is no sound input for more than
30 seconds while INPUT is at DIGITAL and the source
connected through DIGITAL IN. The deck changes to
recording pause and the 30 seconds of silence are
replaced by a blank of about 3 seconds.
If "Smart Space" appears in the display
The Smart Space Function has been activated. This
happens when there has been an extended silence (of
not more than 30 seconds) between two input signals
when INPUT is at DIGITAL and the source connected
through DIGITAL IN. The Smart Space Function
instantaneously replaces the silence with a blank of
about 3 seconds even as the deck continues recording.
Playing back tracks just recorded
Do this procedure to immediately playback tracks that
have just been recorded.
Press I>DB (or ►-) immediately after stopping
recording.
Playback starts from the first track of the material just
recorded.
To play from the first track of the MD after recording
1 Press H again after stopping recording.
2 I’ress >DD (or ►).
Playback starts from the first track of the ML).
Adjusting the Recording Level
When recording a sound source while INPUT is at
ANALOG and the source connected through LINE
(ANALOG) IN, use RFC I.FV'EL to adjust the
recording level before starfing recording.
You cannot adjust the recording level during digital
recording.
1
2
REC LEVEL
Do Steps 1 to (r in "Recording on an MD" on page 6.
Play the portion of the programme source with the
strongest signal level.
3 While mcanitoring the sound, turn REC LEVEL to
adjust the recording level so that the peak level
meters reach their highest point without turning on
the OVER indication. Occasional lighting of
"OVER" is acceptable.
4 Stop playing the programme source.
5 To start recording, do the procedure starting from
Step 8 of "Recording on an MD" on page 6.
8