Sony MDS-S35 - Manual (Page 5)

Getting Started
Hookups
Connecting the deck to an amplifier
Connect the amplifier to the hlNi' IN,/C')UT jacks usiiii; the
audio coni’tectiiv^ ct>rds (supplied), making sure tti match the
colour-coded cord the appropriate jacks on the
components: red (right) to red and white (left) to white.
Be sure to make connectimis firmlv tc^ prex ent huin and
noise.
Connecting the AC power cord
Conned the AC pi)wer cord to a wall outlet or ti' the
outlet ot a timer.
Note
With the exception ot a timer outlet, do not eonneet the AC
power ei'rd to a swithed outlet.
MD deck
LINE
Amplifier
TAPE / MD
Where do I go next?
Ninu i/oii'ir mail/ to i/sc t/oiir dock.
Before usi}if; the MD deek, turn 0}i the iiiiifilifier and eelect
the MD deek u’ith the soni ee eeleelor on the amplifier.
Connecting the deck to a digital component such as a CD
player, DAT deck, digital amplifier, or another MD deck
Connect the component through the DIGITAL l.N/OUT
connectors using the optical cable (not supplied). Take ott
the cap and plug in the optical cable.
MD deck
DIGITAL
Digital component
C_ DIGITAL
IN OUT IN
....... \?/
OUT
Signal flow
Notes
• Digital programme sources vedth ditferent sampling
trequencies cannot be recorded through the digital iiipuL
jack.
Only CD, MD (premastered) and DAT sources with a
sampling frequency ot 44.1 kHz can be recorded through the
digital input connector. "Din Unlock" appears in the
display when you attempt to record digital programme
sources with a sampling trequency ditferent from that of the
MD (such as 32- or 43-kHz DAT or BS). To record these
programme srrurces on an MD vou must connect them
through the analogue LINE IN jacks and set INPUT to
ANALOG.
• If "Cannot Copy" appears in the display, recording through
the digital jack is not possible.
In this case, record the programme source through the LINE
IN and OUT jacks with INPUT set to ANALOG.
• When recording through the DIGITAL IN connector, you
cannot adjust the recording lewd.