Sony SLV-790HF - Manual (Page 6)

step 2: Setting up the remote commander (continued)
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If your
TV is listed in the table below, set the appropriate manufacturer's code
number.
1
Set [TV]/| V I K at the top of the remote commander to ¡TV].
2
Hold down POWER, and enter your TV's code number(s) using the
number buttons. Then release POWER.
Now you can use the POWER, VOL + / - , CH -r/- and TV/VTR buttons to
control your TV. You can also use the buttons marked with a dirt (•) to
control a Sony TV. To control the VCR, reset !T'^/|VTR] to VTR].
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at a time until
vou find the one that works with vour TV.
Manufacturer Code
number Manufacturer Code
number Manufacturer Code
number
Sony 01 KMC 03 RCA 04,10
Akai 04 Magna vyix 03,08,12 Sampo 12
AOC 04 Marantz 04,13 Sanyo 11
Centurion 12 MGA/Mitsubishi 04,12,13,17 Scott 12
Coronado 03 NEC 04,12 Scars 07,10,11
Curis-Mathes 12 Panasonic 06,19 Sharp 03,05,18
Daytron 12 Philco 03,04 Sylvania 08,12
Fisher 11 Philips 08 Teknika 03,08,14
General Electric 06,10 Pioneer 16 Toshiba 07
Hitachi 02,03 Portland 03 Wards 03,04,12
l.C.Penny 04,12 Quasar 06,18 Yorx 12
JVC 09 Radio Shack 05,14 Zenith 15
Notes
• If the TV uses a different remote control system from the one programmed to work
with the VCR, you cannot control vour TV with the remote commander.
• If you enter a new code number, the code number previously entered will be erased.
• When you replace the batteries of the remote commander, the code number
automatically resets to 01 (Sony). Reset the appropriate code number.
6 I Getting Started