Sony STR-V200 - Manual (Page 7)

Getting Started
AC Hookups
Connect the AC power cord from this receiver and
from your audio/video com{^nents to a wall outlet.
If you connect a component to AC OUTLET on the
receiver, the receiver can supply power to the
connected component so you can turn on/off whole
system when you turn on/off the receiver.
AC OUTLET
to a wall
outlet
Caution
Make sure that the power consumption of the component
connected to receiver's AC OUTLET does not exceed 120
watts. Do not connect high-wattage electrical home
appliances such as electric irons, fans, or TVs to this outlet.
Before using the receiver for the first
time
Do the procedure below to set the receiver's stored
parameters (preset stations, etc.) to their factory
settings.
l/(!) TAPE/MD
VIDEO CD
1 Turn off the receiver.
2 While pressing down VIDEO, TAPE/MD,
and CD, press 1/(1) to turn on the receiver.
"INITIAL" appears in the display and the
stored parameters are set to their factory
settings.
Before You Use Your Receiver
Before you start using your receiver, make sure that
you have:
• Turned MASTER VOLUME to the leftmost position
(
0
).
• Set BALANCE to the center position.
Turn on the receiver and check the following indicator.
• Press MUTING on the remote if "MUTING" appears
in the display.