Sony STR-V200 - Manual (Page 17)

Additional Information
Specifications
AUDIO POWER SPECIFICATIONS
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION
With 8 ohm loads, both
channels driven, from 20 -
20,000 Hz; rated 50 watts
per channel minimum RMS
power, with no more than
0.09% total harmonic
distortion from 250
milliwatts to rated output.
Amplifier section
POWER OUTPUT
stereo mode
(8 ohms 20 Hz - 20 kHz,
THDO.09%)
50W + 50W
Surround mode (8 ohms at 1 kHz, THD
0
.
8
% )
Front: 50W/ch
Center*: SOW
Rear*: 50W/ch
* Depending on the
surround mode and the
source, sound will not be
output.
Frequency response
CD, TAPE/MD, TV/DBS,
VIDEO:
10 Hz - 50 kHz ±1 dB
Inputs
Sensitivity Impedance S/N
(weighting
network,
input level)
CD 200 mV
82 dB
TAPE/MO, 150 mV 50 kilohms (A, 150
TV/DBS,
,nv)
VIDEO ’
Outputs TAPE/MD REC OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
VIDEO AUDIO OUT:
Voltage: 150 mV,
Impedance: 10 kilohms
MIX AUDIO OUT:
Voltage: 2 V
Impedance: 10 kilohms
PHONES:
Accepts low and high
impedance headphones
MUTING Full mute
BASS BOOST +10 dB at 70 Hz
TONE ±8 dB at 100 Hz and 10 kHz
FM tuner section
Tuning range 87.5 -108.0 MHz
Antenna terminals
300 ohms, balanced
75 ohms, unbalanced
Sensitivity Mono: 18.3 dBf, 4.5 pV
Stereo: 38.3 dBf, 45 pV
Usable sensitivity
11.2 dBf, 2 pV (IHF)
S/N Mono: 0.3%
Stereo: 0.5%
Harmonic distortion at 1 kHz
0.5%
Separation 45 dB at 1 kHz
Frequency response
30 Hz -15 kHz ^ dB
Selectivity 60 dB at 400 kHz
AM tuner section
Tuning range With 10 kHz interval: 530 -
1710 kHz**
Antenna Loop antenna
Usable sensitivity
50 dB/m (at 1,000 kHz)~
S/N 54 dB (at 50 mV/m)
Harmonic distortion
0.5% (50 mV/m,
400 Hz)
Selectivity At 10 kHz: 40 dB
General
System Tuner section:
PLL quartz-locked digital
synthesizer system
Preamplifier section:
Low-noise NF type
equalizer
Power amplifier section:
Pure-complementary
SEPP
Power requirements
120 V AC, 60 Hz
Power consumption
150 W
AC outlets 1 switched, 120 W/1 A
maximum
Dimensions 355 x 120 x 325 mm
(14 X 4 V* X12 ’/4 inches)
including projecting parts
and controls
Mass (Approx.)
5.9 kg (13 lb)
Supplied accessories
See page 4.
Design and specifications are subject to
change without notice.
18
* You can change the AM tuning
interval to 9 kHz or to 10 kHz. After
tuning in any AM station, turn off
the receiver. Hold down the
TUNING + button and press the 1/(1)
button. All preset stations will be
erased when you change the interval.
To reset the interval to 10 kHz, repeat
the procedure.