Audio component hookups, Overview, White (l) red(r) – Sony STR-V200 User Manual
Page 5: Hookups, Speaker system hookups, Black cqlt, Getting started
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Getting Started
Audio Component Hookups
Overview
This section describes how to connect your audio
components to the receiver. If you want to use the
receiver as an amplifier, complete these connections.
CD TAPE/MD
What cords will I need?
Audio cords (not supplied) (1 for a CD player; 2 for a tape
deck or MD deck)
White (L)
Red(R)
Hookups
The arrow
CD player
White (L)
Red (R)
indicates signal flow.
Receiver
CD player
CO
DumiT
UMC
Tape deck or MD deck
Receiver
Tape deck or MD deck
TAPEMO
OUTPUT MPUT
M
UNE
UNE
Speaker System Hookups
Overview
This section describes how to connect your speakers to
the receiver. Although front (left and right) speakers
are required, center and rear speakers are optional.
Adding center and rear sf>eakers will enhance the
surround effects. Connecting an active woofer will
increase bass response.
REAR FRONT
MIX CENTER
For optimum surround sound effect, place your
speakers as shown below.
Rear speaker
What cords will I need?
• Sp>eaker cord (not supplied) (1 for each speaker)
(+)
{-)
(+)
(-)
Twist the stripped ends of the cord about 2/3 inch (15
mm). Be sure to match the speaker cord to the appropriate
terminal on the components: + to + and - to -. If the cords
Me reversed, the sound will be distorted and will lack
bass.
Monaural audio cord (not supplied) (1 for an active
woofer)
Black cQlt: