Sony STR-AV770X - Manual (Page 14)

T63A
Radio Reception
Tuning in a Station Directly — Direct Tuning
2 Select FM or AM.
4 Enter the frequency.
[1 |2 |3 |4 |5 |6
The entered frequency is displayed.
Example 1: FM 102.50 MHz Example 2: AM 1350 kHz
1 0 2 5 0 1 3 5
151515 B
" I D L n .... AM 1 1 C p kHz
FM l U L . J U 1 J J U
To correct the entered frequency
Repeat Steps 3 to 4.
For entering AM frequencies, you need not enter the
last “0".
However, if you have changed the AM tuning interval to 9
kHz, enter all the digits.
If you enter a frequency not covered by the tuning
interval
The entered value is automatically rounded up or down to
the closest value covered by the tuning interval.
Tuning intervals for direct tuning are the followings:
FM: 50 kHz interval
AM: 10 kHz interval (changeable to the 9 kHz interval)
When the entered number is not in the receivable
frequency range
The entered digits (up to 5 digits for FM or up to 3 digits for
AM) blink in the frequency display area, and reception
does not take place.
If this occurs, press TUNING DIRECT again, and enter the
correct frequency (the frequency range of the receiver is
87.50 to 108.0 MHz for FM, and 530 to 1710 kHz for AM).
When an FM stereo program is noisy
When the unit receives an FM stereo program, the STEREO
indicator goes on in the display window. If the stereo
program is noisy, press FM MODE to change the mode
over the MONO. This eliminates the stereo effect, but the
noise will be greatly reduced.
To return to the stereo mode, press FM MODE again.
14