Sony STR-DE725 - Manual (Page 35)

Automatic Tuning Preset Tuning
For details on the buttons used in this section, see “Brief
descriptions of buttons used to receive broadcasts ’ on
page 35.
1 Press TUNER to light the button up. »
The last received station is tuned in.
2 Press FM/AM to select the FM or AM band.
3 Press TUNING + or TUNING-.
Press the + button to scan from low to high; press the
button to scan from high to low.
For details on the buttons used in this section, see “Brief
descriptions of buttons used to receive broadcasts ’ on
page 35.
Before tuning to preset stations, be sure to preset them by
performing steps on “Presetting radio stations’’ below.
Presetting radio stations
1 Press TUNER to light the button up.
The last received station is tuned in.
70
O
n
(D
3
(O
09
5
0>
a
n
0)
When the receiver reaches either end of the
band
Scanning is repeated in the same direction.
The receiver stops scanning whenever a station is
received.
4 To continue scanning, press TUNING + or TUNING -
again.
Tune in the station that you want to preset using
Direct Tuning (page 35), or Automatic Tuning (this
page).
Press MEMORY.
“MEMORY" appears in the display for a few seconds.
Do Steps 4 to 6 before “MEMORY" goes out.
Press SHIFT to select a memory page (A, B or C).
Each time you press SHIFT, the letter “A”. “B" or “C”
appears in the display.
Select a preset number by pressing it (0 to 9).
If “MEMORY" goes out before you press the preset
number, start again from Step 3.
6 Press MEMORY again to store the station.
If “MEMORY" goes out before you press the preset
number, start again from Step 3.
7 Repeat Steps 2 to 6 to preset another station.
To change a preset number to another station
Do Steps 1 to 6 to preset the new station to the number.
Note
If the AC power cord is disconnected for about one week, all the
preset stations will be cleared from the receiver 's memory, and
you will have to preset the stations again.
36