Sony SLV-998HF - Manual (Page 10)

step 3: Hookups (continued)
B Use this hookup if your TV has the S-Link™ function
VCR Stereo receiver
Note
• To play a tape in stereo, you must use the A/V connection.
A7V hookup: VCR setup
After you've connected your TV and completed antenna or cable hookup,
use the following procedure to set up the VCR.
Press MENU and select
ADVANCED OPTIONS.
Set AUTO ANT SEL to
OFF and press OK.
TIMER SET/CHECK
TUNER PRESET
CLOCK SET
LANGUAGE
SET VCR Plus+ CHANNELS
CABLE BOX CONTROL
advanced OPTIONS
Use ♦'I to select
i t em, t hen push ^
AUTO AMT see
AUTO STEREO
AUDIO MIX
TUNER AUDIO
SHARPNESS
ON bFF:
ON: OFF
ON
OFF
SAP
L - - H
Use Io selecj______________ ar
I tem, then push [♦■»I
For details, see page 81.
Caution
Connections between the VCR's VHF/UHF connector and the antenna terminals of
the TV receiver should be made only as shown in the following instructions. Failure
to do so may result in operation that violates the regulations of the Federal
Communications Commission regarding the use and operation of RF devices. Never
connect the output of the VCR to an antenna or make simultaneous (parallel) antenna
and VCR connections at the antenna terminals of your receiver.
Note to CATV system installer (in USA)
This reminder is provided to call the CATV system installer's attention to Article 820-
40 of the NEC that provides guidelines for proper grounding and, in particular,
specifies that the cable ground shall be connected to the grounding system of the
building, as close to the point of cable entry as practical.
10 Getting Started