Sony SLV-688HF - Manual (Page 6)

step 2: Setting up the remote commander (continued)
Controlling other TVs with the remote commander
The remote commander is preprogrammed to control non-Sony TVs. If yo
TV is listed in the table below, set the appropriate manufacturer's code
number.
1
Set pfvl/[yiDE^i at the top of the remote commander to pfVi.
2
Hold POWER down, and enter your TV's code number(s) using the
number buttons. Then release POWER.
Now you can use the POWER, VOL +/-, CH +/- and TV / VIDEO buttons
control your TV. You can also use the buttons marked with a dot (•) to
control a Sony TV. To control the VCR, reset TV]/ ¡VIDEO^ to | VIDEO|.
Code numbers of controllable TVs
If more than one code number is listed, try entering them one at a time unt
you find the one that works with your TV.
Manufacturer Code
number Manufacturer Code
number Manufacturer Code
number
Sony 01 JVC 09 RCA 04,10
Akai 04 KMC 03 Sampo 12
AOC 04 Magnavox 03,08,12 Sanyo 11
Centurion 12 Marantz 04,13 Scott 12
Coronado 03 MGA/Mitsubishi 04,12,13,17 Sears 07,10,11
Curis-Mathes 12 NEC 04,12 Sharp 03,05,18
Daytron 12 Panasonic 06,19 Sylvania 08,12
Emerson 03,04,14 Philco 03,04 Teknika 03,08,14
Fisher 11 Philips 08 Toshiba 07
General Electric 06,10 Pioneer 16 Wards 03,04,12
Gold Star 03,04,17 Portland 03 Yorx 12
Hitachi 02,03 Quasar 06,18 Zenith 15
J.C.Penny 04,12 Radio Shack 05,14
Notes
• If the TV uses a different remote control system from the one programmed to worl
with the VCR, you cannot control your TV with the remote commander.
• If you enter a new code number, the code number previously entered will be erase
• When you replace the batteries of the remote commander, the code number
automatically resets to 01 (Sony). Reset the appropriate code number.
Getting Started