Citizen Systems Citizen CL-S700 - Manual (Page 45)

45
Printer Operation
Emulation Auto-Detection
Ordinarily emulation switching is conducted in the Menu Setup mode.
However, switching can also be conducted using the Emulation Auto-
Detection function outlined below.
The following message is displayed on the LCD when the Zebra emulation
(ZPI2) command is detected during Datamax emulation.
ZPI2 detected.
Switch
emulation ?
No Yes
By selecting “Yes” the printer will reboot and automatically switch to ZPI2
emulation. The printer will return to the On Line Ready status if “No” is
selected.
The following message is displayed in the LCD when the Datamax command
is detected during Zebra emulation.
DMX detected.
Switch
emulation ?
No Yes
By selecting “Yes” the printer will reboot and automatically switch to Datamax
emulation (DM4/DMI/DPP). The printer will return to the On Line Ready
status if “No” is selected.
Note: • The Emulation Auto-Detection function will not work if the
“Emulation Auto Detect” command in the Sub Menu in the “System
Setup” in the Top Menu is set to “Off ”. (The command is set to
“On” when shipped from the factory)
• After the Emulation Auto-Detection function is activated once, this
function will not work again unless the printer is turned OFF and
ON.
Menu Setup Mode
(p.29, p38, p42)