Sony KV-27XBR25 - Manual (Page 66)

Using the Pre-Programmed Remote Commander
Operating a cable converter box
Follow these instructions to set the manufacturer’s code,
which will enable you to operate a connected cable
converter box with the pre-programmed Remote
Commander.
Example: Operate a connected Zenith cable converter box.
Remote Commander (RM-Y113)
(with video control cover open)
MUTING
1=1
SLEEP POWER
01=1
CH+ FREEffi TVAflOEO SWAP PIP oo ooo
CH- o
TV/VDEO
FOariON AUDIO OFF
ANT/AUX
o
HEAD
PHONES o
DISPLAY ^ tmcfi
l=l®C3
ENTER
A/V WINDOW________
ŒI
CH VOL
TV CABLE BOX
tû
TV/VTR CODE SET STANDARD
1=1 □ (=1
1 Set the TV/CABLE BOX selector to CABLE BOX.
TV CABLEBOX
on
Vl/hile pressing CODE SET, press 6 and 8 (Zenith’s
code number — see Rg. 8) and ENTER.
CODE SET
(5
3 Use the TV control buttons (POWER, 0-9, ENTER
and CH +/-) to operate the cable converter box.
POWER
©(D@
©®®
@®®
o®g
CH
To return to the normat screen
Set the TV/CABLE BOX selector to TV; then use the TV
control buttons to control the TV.
For more details on operating the cable box
Refer to the operating instructions that come with the
cable box.
Fig. 8: Cable box manufacturer code numbers
MANUFACTURER CODE
JERROLD 60,61,62,63,64,65
PIONEER 69,70
SCIENTIFIC ATLANTA 66,67
TOCOM 71,72
ZENITH 68
Notes
• If more than one code number is listed, try entering them one by
one, until you come to the correct code for your equipment.
• If you enter a new code number, the code number you previously
entered at that setting is erased.
• In some rare cases, your equipment may use a code that is not
provided with this Remote Commander and you may not be able
to operate your cable converter box with the supplied Remote
Commander. In this case, use the equipment’s own remote
control unit.
66
I
Chapter 3: Using Advanced Features