Sony CCD-TR66 - Manual (Page 20)

Using Alternative Power Sources
WARNING
AC power cord must only be changed at qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (mains) as long as it is connected
to the wall outlet, even if the set itself has been turned off.
Notes on the POWER lamp
• The POWER lamp will remain lit for a while even if the unit is unplugged after use.
This is normal.
• If the POWER lamp does not light, disconnect the power cord. After about one
minute, reconnect the power cord.
To remove the adaptor
The adaptor is removed in the same way as the battery pack.
Using the Battery Case
Use the battery case (supplied) and six size AA (LR6) alkaline batteries (not supplied).
( 1 ) Remove the battery holder from the battery case.
( 2 ) Insert six new alkaline batteries into the battery holder, following the marking on
the holder to be sure the batteries are installed in the correct direction.
(3) Insert the battery holder with the alkaline batteries.
(4) Insert the battery case with the alkaline batteries to the battery mounting surface of
the camcorder in the same way as the battery pack (p. 8).
Battery Life
Using alkaline batteries at 77°F (25°C)
Typical recording time Continuous recording time
90 min. 165 min.
Notes
• The above battery lives are estimates. The battery life may be shorter depending on
the storage condition of the battery before being purchased and temperature.
• You may not use the battery case in clold environment.
20